Same Day Service Available in Fort Worth

HVAC, Plumbing and Electrical in Haltom City, From an Office in Haltom City

Haltom City water tower with the city logo

Astar is based in Haltom City. Our office sits at 1315 Colony Ct, off Beach Street between Loop 820 and Carson Street, which means a Haltom City call is usually the shortest drive our technicians make all day. We repair and replace air conditioning, heating, plumbing and electrical systems across the 76117 and 76137 ZIP codes, seven days a week, with 24/7 emergency service when something fails at night.

Service

Haltom Service

Plumbing

Water heaters, slab leaks, drain and sewer lines, repipes and gas work. On a mid-century slab home the two calls that matter most are the slab leak and the sewer line, because both get expensive quickly if they are diagnosed late.

Electrical

Electrical repairs, panel upgrades, wiring, outlets and circuit breakers. From flickering lights and overloaded circuits to EV charger installation and surge protection, Astar helps keep Haltom City homes safe, reliable and powered.

Licensed, and local in the literal sense

Astar holds Texas licenses in all three trades: TACLB00028662E for air conditioning and refrigeration, M-46192 for plumbing, and TECL-38309 for electrical. One company, three licenses, which means a problem that crosses trades does not turn into three separate appointments and three separate diagnoses.

Haltom City water tower with the bison mural beside the red Haltom City sign

What we see in Haltom City homes

Most of Haltom City was built before 1980. The median home here dates to the late 1970s, and close to four in ten were built between 1940 and 1969. That age shows up in predictable ways, and after years of working these streets we tend to know what we will find before we open the panel.

Galvanized supply lines are the one homeowners hear about most. Fort Worth Water has been flagging galvanized service lines on the customer side, and plenty of Haltom City homes still have the original pipe. It corrodes from the inside, so the first symptom is usually pressure that has quietly dropped over years rather than a leak. We can tell you whether what you have is galvanized, copper or PEX in a few minutes.

Cast iron drain lines are the second. A mid-century slab home on clay soil moves with the seasons, and cast iron that has been in the ground sixty years does not move with it. Recurring slow drains in the same part of the house are worth a camera inspection before they become a slab repair.

On the electrical side, a house wired in the 1950s or 1960s was wired for a fraction of the load a family puts on it now. Sixty and one hundred amp panels are still out there, along with a few brands that no longer have breakers available. If your lights dim when the AC starts, that is the panel talking.

And cooling in these homes is almost always a retrofit. Central air was not standard when much of Haltom City went up, so the ductwork was added later, often into an uninsulated attic. Rooms at the end of a run never quite keep up, and the system runs longer than it should to make up for it.

Air conditioning and heating

We repair every brand and we are straight about the repair-or-replace decision. A system under about twelve years old with a failed capacitor or contactor is worth repairing. A system past fifteen with a compressor fault usually is not, and we will tell you that before you spend money on a diagnosis that leads nowhere.

Summer calls in Haltom City are weighted toward capacitors, contactors, condensate drains that have backed up in a tight attic, and refrigerant leaks in line sets run through hot spaces. Winter calls are mostly ignition, flame sensors and heat exchangers on furnaces that have been in place a long time.

FAQs

Frequently Asked Questions

Yes. Our office is at 1315 Colony Ct, Ste C, Haltom City, TX 76117. We are not a Dallas company with a Fort Worth phone number. For most Haltom City addresses we are a short drive, which is why same-day appointments here are usually easy to fill.

Galvanized pipe is dull grey and magnetic, and the threads at the fittings are usually visible. Copper is reddish brown and PEX is flexible plastic. The easiest place to look is where the line enters the water heater. If you are not sure, a technician can tell you in a couple of minutes during any visit, at no extra cost.

A brief flicker when a large motor starts can be normal. Lights that dim noticeably and stay dim, breakers that trip when two appliances run together, or a warm panel cover are not normal and are worth an inspection. In homes of this age the cause is often a sixty or one hundred amp panel carrying a modern load.

Yes. Water heater replacement requires a permit and inspection, and the permit has to be pulled by a licensed plumber. We pull it as part of the job and include the inspection in the price we quote, so there is nothing for you to file.

We answer the phone 24 hours a day and dispatch a technician, not a call center. Any after-hours rate is quoted before we come out, so you approve the number before anyone is dispatched. There is no charge for the call itself.

โ—† Help Is On The Way

The Astar Truck Will Be at Your Curb Today.

Same day appointments across Fort Worth & Tarrant County. Fully-stocked trucks, friendly uniformed techs, upfront flat-rate pricing, call now and we’ll be there.

24/7 emergency line Read our Google reviews
817-290-3373
Astar service van in the company's blue and red wrap
Avg. ETA < 90 minin Fort Worth