When a drain keeps clogging, a snake usually just punches a hole through the blockage. Hydro jetting scours the entire pipe wall with high-pressure water, clearing grease, scale and tree roots so the line flows properly again. Our licensed plumbers use it for stubborn and recurring clogs and for main lines, with an upfront price and our 100% satisfaction guarantee.
| Drain snake | Hydro jetting | |
|---|---|---|
| How it works | A cable bores through the blockage | High-pressure water cleans the full inside of the pipe |
| Best for | One-off clogs in a single drain | Grease, scale, roots and repeat clogs |
| What it leaves behind | Buildup on the pipe walls | A clean pipe wall |
| Typical next step for repeat clogs | Another visit | A camera inspection to confirm the cause |
For a single slow sink or tub, standard drain cleaning with a snake is usually all it takes.
Clogs are not only a household nuisance. The U.S. Environmental Protection Agency lists blockages and line breaks among the causes of sanitary sewer overflows, when sewers release raw sewage, and estimates at least 23,000 to 75,000 of those overflows a year across the country, not counting sewage backups into buildings. Grease is one of the usual culprits. It goes down the drain warm, cools and coats the pipe, and over time the opening narrows until the line backs up. Jetting removes that layer instead of poking through it.
We typically start with a sewer camera inspection to confirm the cause and rule out a collapse or break, then jet the line clean. In many older Fort Worth neighborhoods, recurring clogs trace back to cast-iron or clay sewer lines and tree roots. Fort Worth Water lists a sewer main and cast-iron water main replacement project for the North Side area, which takes in the Stockyards and the streets around it. Seeing inside the pipe first means we solve it rather than coming back next month. If the camera shows a fragile, cracked or collapsing section, we recommend a repair instead of jetting a failing pipe.
Hydro jetting cost depends on the line’s size, its length and how severe the blockage is. We diagnose first and give you a flat, upfront price before starting, and if a sewer line repair is the better long-term answer, we tell you honestly. To get a line jetted, call us at 817-290-3373 or book online.
Call 817-290-3373 or book online.
Snaking clears most simple, one-off clogs. Hydro jetting is better for grease, scale, tree roots and recurring or main line clogs, because it cleans the full pipe wall instead of just poking a hole. For repeat clogs, jetting plus a camera inspection usually solves the cause.
Because it removes buildup from the whole pipe, results typically last much longer than snaking, depending on the line’s condition and what caused the clog. A camera inspection helps set the right expectation.
For most pipes, yes. That is why we inspect the line with a camera first. If we find a fragile, cracked or collapsing section, we recommend a repair rather than jetting.
Cooking grease goes down the drain warm, cools and sticks to the pipe walls, narrowing the opening over time. The EPA lists blockages among the causes of sewer overflows. Jetting removes the layer completely.
It can clear roots growing into the line. Because roots come back where a joint is open, we use the camera to show whether the pipe also needs repair.
Same day appointments across Fort Worth & Tarrant County. Fully-stocked trucks, friendly uniformed techs, upfront flat-rate pricing, call now and we’ll be there.